Welcome, Guest
Username: Password: Remember me

TOPIC: firmware update

firmware update 2 years 6 months ago #688

Adam,
I have the hex file on my desktop and issued the following command line:

avrdude -c arduino -p m1284 -b 115200 -P\\.\COM3 -U flash:w:brewtroller.cpp.hex

I got a brief flash but no reaction on the brewtroller, so I am assuming that there is an issue (communications?) Do you see any issues in the command line I executed via run? I am sure I need to update/correct some of my set ups so I will be doing this until I get it configured and running correctly.
Thank you,
Mike
The administrator has disabled public write access.

firmware update 2 years 6 months ago #689

  • adam
  • adam's Avatar
  • Offline
  • Administrator
  • Posts: 209
  • Thank you received: 19
  • Karma: 5
Couple of thing to check. Make sure your com port is right. Then what version of the board are you using? 1.0 or 1.1?
____________________________________
Adam Shake
Owner - BrewTroller
The administrator has disabled public write access.

firmware update 2 years 6 months ago #690

Adam,
Yes Com port 3 is the one and I have a Phoenix 1.0. I will double check the Com port 3 settings after re-connection to double check the transfer rate matches also.
Mike
The administrator has disabled public write access.

firmware update 2 years 6 months ago #691

Adam,
My laptop PC Com port 3 was set at 9600, so I increased it to 115200 to match the command line. I got about a 3 second window with scrolling command line listing but no reaction on the Brewtroller LCD and the PID windows did not update. FYI my Phoenix 1.0 shows 2.6 release 6 so it has the latest stable release, but without the correct hw profile/config set up.
Mike
The administrator has disabled public write access.

firmware update 2 years 6 months ago #692

  • adam
  • adam's Avatar
  • Offline
  • Administrator
  • Posts: 209
  • Thank you received: 19
  • Karma: 5
You won't see anything on the LCD during upload, but you should see the LEDs by the USB jack flash during the upload.

What did you actually see on the screen during that 3 second scrolling?

-Adam
____________________________________
Adam Shake
Owner - BrewTroller
The administrator has disabled public write access.

firmware update 2 years 6 months ago #693

  • GLAROSE
  • GLAROSE's Avatar
  • Offline
  • New Member
  • Posts: 8
  • Karma: 0
I Adam,
I would like to update Firmware to 2.8.
I have a Phoenix Board ver. 1.1.
I have installed Firmware 2.6.6 using AVRDUDE and Arduino 022. It works fine but I need Triggers based on minimum volumes.
Brewtroller Update A3 or A8 don't work for my board. It seems that Firmware 2.8 uses a different procedure than 2.6 or 2.7.
How does it work
The administrator has disabled public write access.
Time to create page: 0.077 seconds
Follow via Facebook Follow via Twitter

Login