Welcome, Guest
Username: Password: Remember me

TOPIC: Phoenix configuration set up

Phoenix configuration set up 3 years 4 months ago #418

First forum needs to move to new site.
I have my Phoenix on order to replace my dead DX-1 but have lost my original config.h set ups. I have 6-2 way valves, 1-3 way valve, temperature probes in each pot, additional temperature sensors on tap water input (mainly for chill plate cooling input), one on chill plate output (2 chill plates, and manual valve to switch from tap water chill & ice chest chill water with sump pump for final chilling in BK). I have 50' of 1/2" stainless in the HLT for a MT heat exchanger (no MT direct heat) plus a sensor on the MT return (RIMS processing), and two pumps (stainless heads). I hope I have not forgotten anything as It has been about a year and a half since I brewed and played with my system.
Mike Moore
The administrator has disabled public write access.

Phoenix configuration set up 3 years 4 months ago #419

  • adam
  • adam's Avatar
  • Offline
  • Administrator
  • Posts: 209
  • Thank you received: 19
  • Karma: 5
You will get it figured out!! Thats quite the setup you have, would love to see some pics/videos of it!!

I wish I could move the forums to the new site, unfortunatly shopify doesn't enable that!! I'm hoping to turn this .org site into a community site where users share all kinds of things. Got some plans in the works!!
____________________________________
Adam Shake
Owner - BrewTroller
The administrator has disabled public write access.
Time to create page: 0.066 seconds
Follow via Facebook Follow via Twitter

Login